Install Instructions

ManualsBrandsHoneywell ManualsDampersScrew Terminal Adapter Kit for 2 Position Modutrol IV Series 2 Motors

INSTALLATION INSTRUCTIONS

63-2234-01

220741A Screw Terminal Adapter Kit

APPLICATION

The screw terminal adapter plugs onto the quick-connect

terminals of a Modutrol IV motor. Different terminal labels

accommodate the various Modutrol IV motors (see Table

1).

Before installing, adjust motor stroke and set auxiliary

switches, if needed.

INSTALLATION

When Installing This Product…

1. Read these instructions carefully. Failure to follow

them could damage the product or cause a hazard-

ous condition.

2. Check the ratings given in the instructions and on

the product to make sure the product is suitable for

your application.

3. Installer must be a trained, experienced service

technician.

4. After installation is complete, check out product

operation as provided in these instructions.

WARNING

Electrical Shock Hazard.

Can cause severe injury, death or property

damage.

Disconnect the power supply before making

wiring connections to prevent electrical shock

and equipment damage. All wiring must comply

with applicable electrical codes, ordinances, and

regulations.

To install the screw terminal adapter, refer to Fig. 1 and 2

and perform the following steps in sequence.

1. Remove 4 cover screws and remove top cover

from the wiring box. Remove appropriate conduit

plug from wiring box.

2. Select appropriate terminal label and attach to

screw terminal adapter. See Table 1 and Fig. 2.

3. If replacing an existing motor, note wire connec-

tions before disconnecting wires.

4. Position screw terminal adapter over quick connect

terminals and push down into place.

Fig. 1. Screw terminal adapter for Modutrol IV

motors.

IMPORTANT

If motor has an internal transformer, quick-con-

nect terminals need to be cut off from the ends

of the transformer’s 24V secondary lead wires

(brown). These leadwire ends then need to be

prepared for connection to screw terminals.

Strip 1/4-in. insulation off ends and tin wire with

solder or crimp on 1/4-in. lug.

5. Connect field wiring to appropriate screw termi-

nals.

6. Replace cover and 4 cover screws.

7. Check operation of motor.

M27221

Summary of content (2 pages)

PAGE 1
220741A Screw Terminal Adapter Kit INSTALLATION INSTRUCTIONS APPLICATION 1. The screw terminal adapter plugs onto the quick-connect terminals of a Modutrol IV motor. Different terminal labels accommodate the various Modutrol IV motors (see Table 1). 2. Before installing, adjust motor stroke and set auxiliary switches, if needed. 3. 4. Remove 4 cover screws and remove top cover from the wiring box. Remove appropriate conduit plug from wiring box.
PAGE 2
20741A SCREW TERMINAL ADAPTER KIT TERMINAL POSITIONS 123 456 78 ACCESS HOLE TO MOTOR’S STROKE ADJUST POTENTIOMETER T1 T2 R W B SCREW TERMINAL ADAPTER KIT LOCATION FOR TERMINAL LABEL POWER END OF MOTOR M27216 Fig. 2. Location of terminal positions. Table 1. Terminal Label Selection Chart.