Instructions / Assembly

You may bolt your safe to a shelf or floor for added theft protection and resistance to tipping. Your safe
has a pre-drilled bolt-down hole in the floor panel and mounting hardware is provided for securing to
concrete surfaces. If bolting to wood or metal additional hardware will be needed. Check with your
local home center.
To secure your safe to a concrete floor:
1. Select a suitable and convenient location for your safe (Figure 1).
2. Empty the safe and remove the (6) screws securing the
mounting hole
cover plate (Figure 2).
3. Remove the mounting hole cover plate and gasket along
with the cap to
uncover the mounting hole (Figure 3).
4. Tilt the safe onto it’s back side and stick a screwdriver into the
hole to
punch-out the bottom hole cover plug (Figure 4).
5. Turn safe back onto its feet and place your safe in the desired location for mounting, then make a
mark through the hole onto the floor surface creating a drilling guide (Figure 5).
6. Move the safe aside to clear the marked spot for drilling. Then drill a
5
/8 in./16mm diameter hole
with a depth of 2
1
/8 in./54mm and remove any excess dust (Figure 6 and Figure 7).
7. Insert the supplied expanding bolt into the hole and tap into place using a hammer until even with
the floor surface (Figure 8).
8. Hammer a drift punch or phillips head screwdriver into the expanding bolt so that it flares out
and firmly locks into place to prevent it from turning when mounting the safe (Figure 9).
9. Place the safe back into position lined up over the hole and secure in place using the provided
mounting bolt. Secure bolt tightly using the supplied hexagon wrench (Figure 10).
10. Replace the gasket and mounting plate cover by using a phillips screwdriver to replace the 6
screws to secure the mounting plate into place (Figure 11).
Note: Bolting/unbolting of the unit is at the
consumer’s expense and discretion. LH Licensed
Products, Inc. is not responsible for any costs
incurred if the unit has to be replaced.
If you have any questions about mounting the
safe, please check with your local home center/
hardware retailer or independent contractor.
ANCHORING YOUR HONEYWELL 2600 SERIES SAFE
Figure 2
Figure 6
Figure 11
Figure 3
Figure 7
Figure 5
Figure 9
Figure 10
Figure 4
Figure 1
Figure 8
The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell
International Inc. makes no representations or warranties with respect to this product.
LH Licensed Products, Inc. 1.310.323.5722