Safe Manual

1. With the door open, press and hold the lock release button on the inside edge of the safe door (Figure 1).

2. While holding the lock release button, turn the handle to the left, to place the bolts in the locked

position (Figure 2).

3. Enter the preset factory code 159 followed by the * key (Figure 3).

4. If the code is entered correctly, the LED will turn green (Figure 4).

5. You have 5 seconds to turn the handle to the right to retract the bolt into the unlock position

(Figure 5).

6. Press and hold the lock release button and turn handle to the left to put the bolts in the locked

position.

7. Leave the door open and proceed to the “Programming New User Code” section below.

PROGRAMMING NEW USER CODE

TESTING DIGITAL LOCK

Figure 2

Figure 3

Figure 4

Figure 5

1. Locate and press the red programming button on the inside of the door (Figure 1).

2. After you have pressed the red programming button, the LED will ﬂash orange (Figure 2).

3. Enter your new 3 to 8 digit personal passcode followed by the * key (Figure 3.).

4. Immediately reenter the new passcode and press the * key to conﬁrm.

5. If both passcodes match, the LED will turn green and the new passcode is set (Figure 4).

6. If both passcodes do not match, the LED will ﬂash red and revert to the original code (Figure 5).

7. Leave door open.

TESTING NEW USER CODE

1. With the door open and in the locked position(Figure 1) , enter the new personal passcode

followed by the * key (Figure 2).

2. If the new code is entered correctly, the LED will turn green (Figure 3).

3. You have 5 seconds to turn the handle to the right to retract the bolt into the unlock position (Figure 4).

Green LED

Figure 2 Figure 3 Figure 4 Figure 5Figure 1

Green LED

Orange LED Red LED

Figure 1