Installation Guide

LCD TOUCH SCREEN REMOTE CONTROL
Model 40013
User Guide
IMPORTANT SAFETY INSTRUCTIONS S S
1. Read and keep this instruction sheet for future reference.
2. Please note that all fixed wiring appliances should be installed by a qualified
electrician.
3. The supply to the receiver should be connected on its own circuit.
4. Switch off the power at the circuit breaker before working on receiver or ceiling fan.
5. This unit is to be used for the control of a ceiling fan and its electrical source must
be AC 110/120V, 60Hz.
6. Do not install in damp location or immerse into water. For indoor use only.
7. Do not use with solid state ceiling fans.
CAUTION: To reduce the risk of fire or injury, do not use this product in
conjunction with any variable (rheostat) wall control.
RECEIVER INSTALLATION INSTRUCTIONS S-
1. After switching power off @ circuit breaker, remove ceiling fan canopy from the
mounting bracket. Disconnect existing wiring between ceiling fan and supply at
electrical junction box.
2. Slide the receiver into the mounting bracket per FIG.1 being careful not
to pinch the antenna wire.
3. The receiver will be inserted between the down rod and the mounting bracket.
4. Make wiring connections per FIG. 2.
5. Push all connected wires back into the junction box and reinstall the canopy onto
the mounting bracket.
6. Manually set fan speed control to HIGH and set light to ON using the pull chains.
NOTE: For the remote to function properly, the fan must be on HIGH speed and
lights must be ON to use.
CAUTION: Incorrect wire connection can damage this receiver and could
cause injury or fire.
ACTIVATING THE LEARNING PROCESS (SMART SYNC) S
1. After installation is complete and power is turned on, remove the battery cover on
transmitter. Insert batteries (4 AAA, included).
NOTE: Do not mix old and new batteries, alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
2. Use a small screwdriver or ballpoint pen to press and hold the “LEARN” key, located in
the battery compartment (see FIG. 3.), for 3 seconds. Fan will turn on at high speed
and light (if installed) blinks 3 times. This confirms that the SMART SYNC setting is
active. You now have 30 seconds to press the LEARN key. Tap the FAN OFF button to
turn off the fan.
3. If user cannot finish the setting within the 30 seconds time frame the main power
must be turned off and re-started again. This will reset the unit. Repeat step 2 until
the LEARNING feature is activated as indicated.
NOTE: User must press “LEARN” key within 30 seconds after main power is turned on.
It is not necessary to redo the LEARNING setting if just replacing batteries.
DIMMER ON/OFF SETTING (D/O SWITCH) )
Slide the D/O switch, located in the battery compartment (See FIG. 3), to match the bulb
type in your fan. “D” is for incandescent bulbs and “O” indicates compact fluorescent
bulbs (CFL). Use a small screwdriver or ballpoint pen to slide firmly left or right.
CAUTION: Incorrect bulb setting can damage the receiver.
FAN CANOPY MOUNTING
BRACKET
FIG 1
INSERTING RECEIVER
INTO CANOPY ASSEMBLY
+
AAA
- -
AAA
+-
AAA
+
AAA
-
+
D/O
LEARN
FIG 3
REAR VIEW OF TRANSMITTER – SHOWN WITH
BATTERY COVER REMOVED
D/O (DIMMER SWITCH)
Learn Key
AC POWER (BLACK)
NEUTRAL (WHITE)
ANTENNA
LIGHT
(BLUE)
MOTOR
(BLACK)
MOTOR
(WHITE)
FIG 2
CONNECTING THE RECEIVER
TO THE FAN