User`s guide

3 - 8
To rename image scanners with sequential, numeric names, scan the barcodes
below.
Scan the Reset code after each name change and wait for the scanner
to re-link to the base before scanning another barcode to rename the next
image scanner.
Alternatively, you may change the name with a barcode command if you cannot
send serial commands to the base. One way to do this is to scan the barcode
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the barcode below with the first image
scanner, scan the 1 barcode on the Programming Chart inside the back cover
of this manual and scan Save. Then scan the Reset barcode and wait for the
scanner to re-link to the base before scanning the next barcode. Repeat that
process for image scanner number 2, 3, 4, etc.
If you want to assign an alphabetic name to the image scanner, create a Code
128 barcode containing “~BT_NAM
name .” followed by a FNC3 character (hexi-
decimal 83), where
name is the new image scanner name. Scan the Reset
0001
0002
0003
0005
0007
0004
0006
Reset
Image Scanner Name