User`s guide

4 - 9
Image Snap and Ship
Image Snap and Ship tells the imager to take a picture (rather than read a
barcode) when the trigger is pressed. Once the picture is snapped, it is shipped
to the host system as a jpeg file by default. To revert to barcode reading, you
must change to a different trigger mode (see Serial Trigger Modes beginning on
page 4-4).
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free”
modes. If the image scanner’s trigger is pulled when using a hands free mode,
the image scanner changes to manual trigger mode. You can set the time the
image scanner should remain in manual trigger mode by setting the Hands Free
Time-Out. Once the time-out value is reached, (if there have been no further
trigger pulls) the image scanner reverts to the original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from
0-300,000 milliseconds) from the inside back cover, and Save.
Default = 5,000
ms.
Reread Delay
This sets the time period before the image scanner can read the same barcode
a second time. Setting a reread delay protects against accidental rereads of the
same barcode. Longer delays are effective in minimizing accidental rereads.
Image Snap and Ship
Hands Free Time-Out