Installation Instructions

7
FINAL INSTALLATION
4. Insert blade through slot in the side of the motor assembly. Align the holes of one blade with three blade screw holes in
underside of the motor assembly. Secure with three blade screws and blade washers. Repeat this step for the remaining
blades (Figure 5.4).
5. Remove one of the three fitter plate screws preassembled to the fitter plate and loosen the other two but do not remove.
Connect the single-pin connector from the fitter plate to the single-pin connector from the light kit -- Blue to Black and White
to White. Align the slotted holes in the light kit with the loosened screws in the fitter plate. Turn light kit clockwise and replace
the previously removed fitter plate screw. Tighten all screws (Figure 5.5).
6. Attach the lens cover to the light kit by twisting the lens cover tightly in a clockwise direction (Figure 5.6).
7. If desired, the wall bracket in remote pack can be installed to a wall using the provided mounting screws. The remote can be
stored in the mounting bracket for easy access (Figure 5.7).
8. Remove the battery cover from the back of the remote and insert the 12-volt battery, noting polarity -- positive (+) to positive
(+) and negative (-) to negative (-). Replace the battery cover. If battery is installed correctly, the LED indicator on the front of
the remote transmitter should illuminate when any button is pushed (Figure 5.8).
9. Turn on power to fan at breaker box and the wall switch (Figure 5.9). Assembly is complete.
Figure 5.5Figure 5.4 Figure 5.6
Blade Screw
Blade
Blade Washer
Fitter Plate
Light Kit
Fitter Plate Screw
Slot
Lens cover
Figure 5.8Figure 5.7 Figure 5.9
Screw
Wall
Bracket
Battery
Battery
Cover