User Manual

!
3
SECURE LOCKOUT PERIODS
If a wrong code is entered three times in a row, the digital keypad will begin
a five-minute secure lockout period. During this secure lockout period the
keypad will become disabled. Once the lockout period has expired, the
safe can be unlocked using the correct pass code. You may use the
override key to open safe, but keypad will complete the full lockout period.
OVERRIDE ACCESS KEY
If the pass code is unavailable or your keypad fails due to dead batteries or
other malfunction, you can open the safe using the override access key.
REPLACING BATTERIES
Note: The passcode might be reset to the original factory passcode (159) if
batteries are removed or become too weak. You should always test your
passcode after replacing batteries to ensure it is still active otherwise refer
to step 4 of the “Set-up” section located on page 2 to reprogram your
passcode.
IMPORTANT: The starter batteries included with this product are for testing
purposes only and should be immediately replaced with new alkaline or
lithium batteries. It is NOT RECOMMENDED to use Non-alkaline or
rechargeable batteries.
Weak or dead batteries should be replaced immediately and all 4 batteries
should be changed. To replace the batteries please follow the instructions
in the SETUP section. Remember to always remove batteries from safe if
not using for an extended period of time. If your batteries are completely
dead and you cannot open the safe by using the digital keypad, use the
override access key to open safe and access the battery compartment.
IF YOU FORGET THE PASSCODE
1. Use the override access key to open safe.
2. With door open, press red reset button (C)
inside door.
3. Yellow light is on; enter new pass code in 30
seconds.
4. Enter pass code (3 to 8 digits) followed by
“A” or “B”.
5. Safe will beep and yellow light will turn off.