User`s guide

NSTALLING THE

CANNER TO THE

OST

YSTEM

Integrated USB:

Full Speed MS1690-40

Low Speed MS1690-38

1. Turn off the host device.

2. Plug the male 10-pin RJ45 end of the

USB cable into the 10-pin socket on

the MS1690. There will be an audible

click when the connector lock engages.

3. Plug the USB type A end of the USB

cable into the host’s USB port.

4. Turn on the host device.

5. The MS1690 will start to initialize. All

LEDs (yellow, white, and blue) will light

for approximately 2 seconds then start

to alternately flash. When the scanner

has finished initializing the LEDs will

stop flashing and the unit will beep

3 times indicating that the scanner is

ready for use.

As a default, the MS1690-38 leaves the factory with USB Keyboard

Emulation Mode enabled.

For information on configuring the MS1690-38 for USB Serial Emulation

Mode, please refer to the USB section of the MetroSelect Single-Line

Configuration Guide (

MLPN

00-02544).

Plugging the scanner into a port on the host device does not guarantee

that scanned information will be communicated properly to the host

device. The scanner is shipped from the factory configured with default

settings. Please refer to the MetroSelect Single-Line Configuration

Guide (

MLPN

00-02544) or MetroSet2’s help files for instructions on

changing the scanner’s configuration. In addition, please check that the

scanner and host system are using the same communication protocol.

See power source caution statement located on page 6 of this manual.

Figure 10.