Home Security System User Manual
Table Of Contents
- ONYX®FirstVision™
- Fire Alarm System Limitations
- Installation Precautions
- FCC Warning
- Section 1 Introduction
- Section 2 FirstVision Installation Instructions
- Section 3 Enabling FirstVision to Monitor Your Building
- 3.1 Process Overview
- 3.2 Make Connections to FirstVision
- 3.3 Turn on Power to FirstVision
- 3.4 Set the FirstVision Clock and Time Zone
- 3.5 Establish Communication Between Your LAN and FirstVision
- 3.6 Establish Gateway Communication
- 3.7 Copy Your Exported Building Design to FirstVision
- 3.8 Display Your Building Design on FirstVision
- 3.9 Test Your Building Design on FirstVision
- 3.10 Touch Screen Calibration
- Section 4 Operating Basics of FirstVision
- 4.1 Normal Operation (No Events Being Reported)
- Figure 4.1 FirstVision Display Example: No Alarms
- Figure 4.2 FirstVision Display Example: Floor Number Button
- Figure 4.3 FirstVision Display Example: Building Information
- Figure 4.4 FirstVision Display Example: Zoomed Floor Plan
- Figure 4.5 FirstVision Display Example: Moving Through a Zoomed Floor Plan
- Figure 4.6 FirstVision Display Example: HAZMAT Information
- 4.2 Investigating Gateway Disconnection
- 4.3 Operation When a Fire Alarm is Received
- 4.4 Operation After a Fire Alarm Has Been Cleared
- 4.5 Accessing the Log File
- 4.1 Normal Operation (No Events Being Reported)
- Section 5 The Development of FirstVision
- 5.1 The Current Situation for a Firefighter
- 5.2 The Technology of FirstVision
- 5.3 Expected Firefighter Interaction with the FirstVision
- 5.3.1 Example Emergency Situations
- Figure 5.1 Fire Scene Scenario Floor Plan Information
- Figure 5.2 Fire Scene Scenario Roof Plan Information
- Figure 5.3 Fire Scene Scenario HAZMAT Information
- Figure 5.4 Fire Scene Scenario Building Information
- Figure 5.5 Example Building Site Plan Information
- Figure 5.6 Example HAZMAT Information
- Figure 5.7 Example Contact Information
- 5.3.1 Example Emergency Situations
- Index
![](/manual/honeywell/53034/home-security-system-user-manual/images/img-26.png)
Enabling FIRSTVISION to Monitor Your Building Establish Gateway Communication
24 FIRSTVISION™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
It is anticipated that the factory settings for a gateway may probably work for your application and
it is recommended you use them, if possible, instead of setting up new settings. If you want to
change the factory settings use the following information
How To Add a Gateway Using the Configuration Tool
The gateway can be changed here, but FIRSTVISION can monitor only one gateway.
Step 1. Start the Configuration Tool.
Step 2. Select Tools > Gateway Configuration.
Step 3. Enter the Gateway IP address.
Step 4. Click OK.
Figure 3.14 Gateway Configuration
Step 5. Close the Configuration Tool.
Step 6. You should now "Copy Your Exported Building Design to F
IRSTVISION".
NOTE: Your LAN connection must be established before you add a gateway.
NOTE: If you change the gateway IP address, you must re-export your building design to XML.
See “How to Export Your Building Design for Copying to FIRSTVISION” in ONYX®FIRSTVISION™
Configuration Tool Manual - 53035.
NOTE: The factory default Gateway IP address setting is: 192.168.0.3. If you need to change
this setting, then use the following information.