Home Security System User Manual
Table Of Contents
- ONYX®FirstVision™
- Fire Alarm System Limitations
- Installation Precautions
- FCC Warning
- Section 1 Introduction
- Section 2 FirstVision Installation Instructions
- Section 3 Enabling FirstVision to Monitor Your Building
- 3.1 Process Overview
- 3.2 Make Connections to FirstVision
- 3.3 Turn on Power to FirstVision
- 3.4 Set the FirstVision Clock and Time Zone
- 3.5 Establish Communication Between Your LAN and FirstVision
- 3.6 Establish Gateway Communication
- 3.7 Copy Your Exported Building Design to FirstVision
- 3.8 Display Your Building Design on FirstVision
- 3.9 Test Your Building Design on FirstVision
- 3.10 Touch Screen Calibration
- Section 4 Operating Basics of FirstVision
- 4.1 Normal Operation (No Events Being Reported)
- Figure 4.1 FirstVision Display Example: No Alarms
- Figure 4.2 FirstVision Display Example: Floor Number Button
- Figure 4.3 FirstVision Display Example: Building Information
- Figure 4.4 FirstVision Display Example: Zoomed Floor Plan
- Figure 4.5 FirstVision Display Example: Moving Through a Zoomed Floor Plan
- Figure 4.6 FirstVision Display Example: HAZMAT Information
- 4.2 Investigating Gateway Disconnection
- 4.3 Operation When a Fire Alarm is Received
- 4.4 Operation After a Fire Alarm Has Been Cleared
- 4.5 Accessing the Log File
- 4.1 Normal Operation (No Events Being Reported)
- Section 5 The Development of FirstVision
- 5.1 The Current Situation for a Firefighter
- 5.2 The Technology of FirstVision
- 5.3 Expected Firefighter Interaction with the FirstVision
- 5.3.1 Example Emergency Situations
- Figure 5.1 Fire Scene Scenario Floor Plan Information
- Figure 5.2 Fire Scene Scenario Roof Plan Information
- Figure 5.3 Fire Scene Scenario HAZMAT Information
- Figure 5.4 Fire Scene Scenario Building Information
- Figure 5.5 Example Building Site Plan Information
- Figure 5.6 Example HAZMAT Information
- Figure 5.7 Example Contact Information
- 5.3.1 Example Emergency Situations
- Index
Operating Basics of FIRSTVISION Investigating Gateway Disconnection
34 FIRSTVISION™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
With the front door open; touching an icon will display information about the image.
Figure 4.6 F
IRSTVISION Display Example: HAZMAT Information
4.2 Investigating Gateway Disconnection
The Gateway Connection Icon in the upper left corner of the user interface indicates whether
F
IRSTVISION is connected to your gateway (a red X displayed inside the icon means that
F
IRSTVISION is not connected).
When you see that the gateway disconnected (red X in icon), F
IRSTVISION will not receive events.
It is absolutely necessary to restore connectivity to the gateway to ensure the most accurate and up
to date information is being displayed. In order to investigate connectivity issues, you need to
operate F
IRSTVISION like a personal computer. To do this:
Step 1. Follow the steps in “Make Connections to F
IRSTVISION” on page 15 to attach a keyboard
and mouse to F
IRSTVISION.
Step 2. Shut down the F
IRSTVISION software application by pressing the Esc key.
See “Establish Communication Between Your LAN and F
IRSTVISION” on page 22 and “Establish
Gateway Communication” on page 23 for information about gateway connectivity.