ENGLISH Operation & Installation Guide Steel Security Safe with Programmable Digital Lock Models 5702, 5703, 5705 & 5706 Read this manual carefully and never store it inside the safe!
Index Welcome / Package Contents ........................................................................ Page 1 Override Access Key / Install Batteries.......................................................... Page 2 Testing Digital Lock / Primary & Secondary User Codes / Programming Primary User Code........................................................................................... Page 3 Programming Secondary User Code / Testing Codes .................................
WELCOME Your Honeywell Steel Security Safe will provide years of safe and secure protection for your valuables, important documents and other personal items. All Honeywell safes are designed and built using the highest manufacturing standards to ensure maximum user satisfaction under a variety of conditions. With proper care, your Honeywell safe will provide “Peace of Mind” for many years to come.
OVERRIDE ACCESS KEY Your safe is equipped with an override access key which allows immediate access in case you forget your user codes or the batteries need to be installed or replaced. 1. Remove override access lock cover by gently pressing on the right edge, rotating clockwise to the right and lifting away from key lock (Figure 1). 2. Insert the override access key into the lock until it stops (Figure 2). 3. With the key inserted turn counter clockwise to the left (Figure 3). 4.
TESTING DIGITAL LOCK 1. Push the safe door to the closed position and turn the knob counter clockwise to the left (Figure 1). 2. Enter the preset primary factory code “1 5 9” followed by # key into the keypad (Figure 2). 3. If the correct code is entered, the keypad will beep twice, and the green LED will light up. The knob can then be turned clockwise to the right to open (Figure 3 & 4). NOTE: You have approximately 5 seconds to open the safe.
PROGRAMMING SECONDARY USER CODE PROGRAM THE SECONDARY USER CODE 1. Open the safe using your primary user code then press the “0” twice on the keypad (Figure 1). 2. Locate and press the red reset button located on the inside edge of the door (Figure 2). 3. The keypad will beep three times and the yellow LED will light up (Figure 3). 4. Enter a new 3-8 digit Secondary user code followed by the # key. The keypad will beep twice and the yellow LED will turn off (Figure 4). 5.
SECURE LOCKOUT PERIOD If the wrong user code is entered into the keypad 3 consecutive times in a row, the keypad will automatically revert to the lockout mode and you will not be able to open the safe using the digital keypad for 20 seconds. If three additional wrong user codes are entered, you will not be able to open the safe using the digital keypad for 5 minutes. During the lockout period entry can be made using the override access key.
ANCHORING YOUR SAFE You may bolt your safe to a shelf / floor for added theft protection and resistance to tipping. Your safe has (2) pre-drilled bolt-down holes in the floor panel. (2) Mounting screws are provided for securing to wood surfaces. If bolting to concrete of metal additional hardware will be needed. Check with your local home center. To secure your safe to a wood shelf / floor: 1. Select a suitable and convenient location for your safe. 2. Empty the safe and remove the carpet. 3.
CONSUMER ASSISTANCE EMAIL: LHLPCustomerService@LHLPinc.com WEBSITE:www.honeywellsafes.com ADDRESS: Consumer Assistance Dept. LH Licensed Products, Inc.860 East Sandhill Avenue Carson, CA 90746 USA TELEPHONE: US/Canada 1-877-354-5457 (Toll Free) Mexico 01-800-288-2872 After English voice recording stops you must then enter 800-860-1677 to complete your call.
ORDERING ADDITIONAL OVERRIDE ACCESS KEYS The following information is required to order keys: 1. PROOF OF OWNERSHIP (1 of 2 Options Below) A) SALES RECEIPT & IDENTIFICATION – INTERNATIONAL ORDERS ONLY! • Copy of sales receipt showing Store, Date & Product Description. • Copy of your picture I.D. (Drivers license, passport, regular I.D.). B) PRODUCT OWNERSHIP VERIFICATION FORM If sales receipt is not available, contact us by email or telephone to request a “Product Ownership Verification Form”. 2.
NOTES 9
Limited Warranty LH Licensed Products, Inc., (“LHLP, Inc.”) warrants that for a period of seven (7) years from the date of purchase, this product will be free from structural or mechanical defects resulting from materials or workmanship. LHLP, Inc., at its sole option and as the purchaser’s sole remedy under this warranty, will repair or replace this product or any component of the product found to be defective during the warranty period.