Safe Manual

4
PROGRAMMING SECONDARY USER CODE
Figure 1 Figure 2 Figure 3 Figure 4 Figure 5
PROGRAM THE SECONDARY USER CODE
1. Open the safe using your primary user code then press the “0” twice on the keypad (Figure 1).
2. Locate and press the red reset button located on the inside edge of the door (Figure 2).
3. The keypad will beep three times and the yellow LED will light up (Figure 3).
4. Enter a new 3-8 digit Secondary user code followed by the # key. The keypad will beep twice and
the yellow LED will turn off (Figure 4).
5. You can now close and lock the safe door and your new Secondary user code is now active.
1. Enter the primary user code followed by the # key into the keypad (Figure 1 & figure 2).
2. If the correct code is entered, the keypad will beep twice, and the green LED will light up
the knob can then be turned clockwise to the right to open. NOTE: You have approximately 5
seconds to open the safe. If you wait any longer, the safe will re-lock and you will have to reenter
the code to open (Figure 3).
To Lock, close safe door and turn knob counter clockwies to the left (Figure 3).
Note:
To test the secondary user code, you can follow the same steps by entering
the secondary user code instead of the primary user code in Step 2.
TESTING CODES
READY
PROCEED
LOW
BATTERY
READY
PROCEED
LOW
BATTERY
Figure 1 Figure 2 Figure 3
READY
PROCEED
LOW
BATT
E
R
Y
READY
PROCEED
LOW
BATT
E
R
Y
Three