ENGLISH Operation & Installation Guide Depository Safe with Programmable Digital Lock Model 5912 Read this manual carefully and never store it inside the safe!
Index Welcome / Package Contents ........................................................................ Page 1 Install Batteries / Unlock & Open Your New Safe.......................................... Page 2 Primary & Secondary User Codes / Programming Primary User Code / Programming Secondary User Code.............................................................. Page 3 Testing Codes / Override Access Key ...........................................................
WELCOME Your Honeywell Steel Depository Safe will provide years of safe and secure protection for your currency and check deposits, important documents and other personal items. All Honeywell safes are designed and built using the highest manufacturing standards to ensure maximum user satisfaction under a variety of conditions. With proper care, your Honeywell safe will provide “Peace of Mind” for many years to come.
INSTALL BATTERIES For your convenience, we have included 1 “9 volt” Battery that provides the power for the electronic locking system. The battery must be installed before using your safe. The battery compartment is located at the bottom of the digital keypad. 1. Remove the battery cover under the keypad housing (Figure 1). 2. Pull out 9 volt battery connecting wire and attach the supplied 9 volt battery (Figure 2). 3.
PRIMARY & SECONDARY USER CODES Your new safe is equipped with a digital lock that can be operated with two separate user codes. You will need to program these user codes with your own 1-8 digit user codes. however, for increased security it is reccommended that you use a minimum of 3 digits when deciding on a Primary and Secondary user code. You must program the Primary user code first. After the Primary user code is programmed and tested you can then proceed to program the Secondary user code.
TESTING CODES UNLOCK AND OPEN THE SAFE 1. Always make sure that the handle is turned counterclockwise fully to the left until it stops so that it is in a vertical position before entering code (Figure 1). 2. Enter your Primary user code followed by # key into the keypad (Figure 2). 3. If the correct code is entered, the keypad will beep twice, the green LED will light up and you will hear a click indicating the handle can be turned clockwise to the right to open.
SECURE LOCKOUT PERIOD If the wrong user code is entered into the keypad 3 consecutive times in a row, the keypad will automatically go into lockout mode and you will not be able to open the safe using the digital keypad for 15 minutes. During the lockout period entry can be made using the override access key.
ANCHORING YOUR SAFE You may bolt your safe to the floor for added theft protection and resistance to tipping. Your safe has (4) pre-drilled bolt-down holes in the floor panel. Mounting hardware is provided for securing to concrete or wood surfaces. If bolting to metal surfaces additional hardware will be needed. Check with your local home center. To secure your safe to a concrete surface: 1. Select a suitable and convenient location for your safe. 2. Empty the safe and remove the floor mat. 3.
USING THE DEPOSITORY DOOR This depository style safe provides a quick option to collect and secure many items without having to open the safe door. To use the depository door follow the steps below. 1. Locate and pull down on the depository door handle (Figure 1 and Figure 2). 2. Once open, place the item you would like to deposit onto the drawer (Figure 3). 3. Lift the depository door upward to the closed position and the contents will drop down to the lower section of the safe (Figure 4).
CONSUMER ASSISTANCE EMAIL: LHLPCustomerService@LHLPinc.com WEBSITE: www.honeywellsafes.com ADDRESS: Consumer Assistance Dept. LH Licensed Products, Inc.860 East Sandhill Avenue Carson, CA 90746 USA TELEPHONE: US/Canada 1-877-354-5457 (Toll Free) Mexico 01-800-288-2872 After English voice recording stops you must then enter 800-860-1677 to complete your call.
ORDERING ADDITIONAL OVERRIDE ACCESS KEYS The following information is required to order keys: 1. PROOF OF OWNERSHIP (1 of 2 Options Below) A) SALES RECEIPT & IDENTIFICATION – INTERNATIONAL ORDERS ONLY! • Copy of sales receipt showing Store, Date & Product Description. • Copy of your picture I.D. (Drivers license, passport, regular I.D.).
Limited Warranty LH Licensed Products, Inc., (“LHLP, Inc.”) warrants that for a period of seven (7) years from the date of purchase, this product will be free from structural or mechanical defects resulting from materials or workmanship. LHLP, Inc., at its sole option and as the purchaser’s sole remedy under this warranty, will repair or replace this product or any component of the product found to be defective during the warranty period.