Home Security System User Manual

GROUP NUMBER
X
This prompt appears if event “2” (user access) was selected. Otherwise it is skipped.
1-8 = group number
[∗] to continue to the “Start” prompt
START SMTWTFS
HH MMAM 0010000
Enter the event’s start time and days of the week to occur.
01-12 = hour; 00-59 = minute; 0 = AM; 1 = PM
Days = position the cursor under the desired days using the [∗] key to move forward, then
press “1” to select the desired day(s)
[∗] to continue
STOP SMTWTFS
HH MMAM 0010000
Enter the event’s stop time and days of the week to occur.
This entry applies only to the following events: 1 (relay on/off); 2 (user access); 3 (latch key
report)
01-12 = hour; 00-59 = minute; 0 = AM; 1 = PM
Days = position the cursor under the desired days using the [∗] key to move forward, then
press “1” to select the desired day(s)
[∗] to continue
REPEAT OPTION
0-4 X
Enter the desired repeat option for this schedule.
e.g., To make a schedule that happens everyday you would select all days with a repeat
count of 1. To make a schedule that runs for one week then stops, select everyday with a
repeat count of 0.
0 = do not repeat; 1 = repeat schedule weekly; 2 = repeat schedule biweekly (every other
week)
3 = repeat every 3rd week; 4 = repeat every 4th week
[∗] to continue
RANDOMIZE
0=NO 1=YES X
Select whether you want this schedule to start and stop at random times.
This option applies only to events 01 (relay on/off) and 11 (periodic test report).
If selected, the scheduled start and stop times will vary within 60 minutes of the “hour”
time. For example, if a schedule is set to start at 6:15pm, it will do so the first time 6:15pm
arrives, but on subsequent days it will start anytime between 6:00 and 6:59 p.m.
[∗] to continue
NOTE: Do not use the random option if the start and stop times are within the same “hour”
setting, otherwise unpredictable results may occur (e.g., the randomized stop time may occur
before the start time).
5-15