Home Security System User Manual

— 39 —

Relay Devices Worksheets

Applicable only if relays (4204), or X-10 devices are used.

 Relays are programmed in the #93 Menu Mode in the Relay Programming Section. Fill in the required data on the

worksheet below and follow the procedure in the Installation and Setup Guide as you enter the data during the displays

and prompts that appear in sequence.

Notes: 1. For 4204 the Device Programming section must be programmed for the device address. Set the DIP

switches on the device for that address.

2. For X-10 devices, use the 1361X10 transformer in place of the transformer that comes in the box with the

control panel.

START

STOP

OUTPUT

DEV #

EV/ZL ZT / P ZL ZT / P

Relay

Group

Restrict

1=4204

2=X-10

Dev Add 4204

or House Code

for X-10

Relay # for

4204 or

Unit Code for

X-10

10.

11.

12.

13.

14.

15.

16.

A = DEVICE ACTION 0 = No Response; 1 = Close for 2 sec; 2 = Close and stay closed; 3 = Pulse on and off

EV = EVENT 0 = Not used; 1 = Alarm; 2 = Fault; 3 = Trouble; 4 = Restore

ZL = ZONE LIST 1-8, 0 = Not Used

"START" ZONE LIST: Upon alarm, fault, trouble or restore of ANY zone in this list, device

action will START.

"STOP" ZONE LIST: Upon restore of ALL zones on this list, device action will STOP. It

need not be same list as used for START.