User's Manual

ManualsBrandsHoneywell ManualsHome Security SystemHoneywell Ademco Vista Series

– 24 –

Device Programming

This menu is used to program keypads, receivers, and relay modules, etc.

Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression

options, and these settings cannot be changed.

From Data Field Programming mode, press #93 to display "ZONE PROG?" Press [0] repeatedly to display "DEVICE PROG?"

PROMPT

EXPLANATION

DEVICE PROG?

1=YES 0=NO 0

Press [1] to enter Device Programming.

DEVICE ADDRESS

01-30, 00=QUIT 01

The device address identifies the device to the control. Enter the 2-digit device address number to match

the device’s physical address setting (01-30).

Press [✱] to accept entry.

Select the type of addressable device as follows:

00 = device not used 03 = RF receiver (5881)

01 = alpha keypad (6139/6160) 04 = output relay module (4204)

02 = fixed-word keypad (6137/6150) 05 = voice (VIP) Module (4285/4286)

DEVICE TYPE

Press [✱] to accept entry.

Alpha or Fixed-Word Keypad

PROMPT

EXPLANATION

01 CONSOLE PART.

If you selected device type 01 (alpha keypad), or 02 (fixed-word keypad), this prompt appears. Enter the

addressable device’s default partition number (01 to maximum number of partitions programmed for system

in field 2*00). This is the primary partition for the device. Enter 9 to make this keypad a "Master" keypad for

the system.

Press [✱] to accept entry.

01 SOUND OPTION

Keypads can be individually programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode

beeps. This helps prevent unwanted sounds from disturbing users in other areas of the premises.

Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:

00 = no suppression

01 = suppress arm/disarm & entry/exit beeps

02 = suppress chime mode beeps only

03 = suppress arm/disarm, entry/exit and chime mode beeps

Press [✱] to accept entry.

RF Expander

PROMPT

EXPLANATION

01 RF EXPANDER

HOUSE I 00

If you selected device type 03 (RF receiver), this prompt appears. Enter the 2-digit House ID (00-31). This

is required if you are using a wireless keypad (5827/5827BD).

Press [✱] to accept entry.

VIP Module

PROMPT

EXPLANATION

01 MODULE PART.

If you selected device type 05 (VIP Module) this prompt appears. Enter the partition number 1-8 in which the

module is located.

Press [✱] to accept entry.

Press 00 + [✱] to exit Menu mode.

Press ✱99 to exit Program mode.