GPS Receiver User Manual

4.2.4.3 Direct To Operation From The FPL 0 Page
If you are presently viewing the active flight plan page there is an easy
method of selecting the Direct To waypoint.
To fly direct to a waypoint in the active flight plan while viewing the
FPL 0 page:
1. Select the FPL 0 page.
2. Turn on the cursor with the B
button and use the left outer
knob to position the cursor over
the desired waypoint (figure 4-
42).
3. Press D. The display will
change to the Direct To page
(figure 4-43), with the identifier of
the selected waypoint.
4. Press F to approve the Direct
To. The NAV 1 page will be dis-
played (figure 4-44) reflecting the
new active waypoint.
5. If you now turn back to the
FPL 0 page, you will see that the
active waypoint is now preceded
by an arrow only, instead of the
(figure 4-45). This is because
there is no “from” waypoint in the
flight plan.
4.2.4.4 Cancelling Direct To Operation
If it is desired to cancel the Direct To operation prior to reaching the Direct
To waypoint in order to proceed along the flight plan leg, press D, then
press E, then F. The unit will orient itself on the closest leg of the
flight plan.
≤≤
≥≥
KLN 94 Pilot’s Guide Chapter 4 Flight Plan Operation
4-13
Figure 4-42
Figure 4-43
Figure 4-44
Figure 4-45