Product Manual

Honeywell BW Solo User Manual
39
13.4.2. 1-Series Sensor Replacement
IMPORTANT!
Some Series 1 sensors are shipped with a jumper that connects two of the pins. This jumper must
be removed before installing the sensor. Turn the sensor upside-down, and slide the jumper off of
the sensor’s pins. Properly dispose of the jumper.
Place the O-ring in the slot on the sensor frame. Invert the sensor so the contacts are showing.
Press the round part of the sensor into the sensor frame, aligning its notch with the matching part of
the sensor frame’s back. Invert the sensor and stretch the O-ring around the perimeter of the
sensor.
Invert the sensor, and press the sensor all the way until it is fully seated in the sensor frame.
1-Series
Sensor
Sensor
Frame
Press in
partway
O-ring
Top
View
Bottom
View
Jumper
Sensor
Jumper
Attached
Jumper
Removed
Jumper