Product Manual
Table Of Contents
- 1. Standard Contents
- 2. General Information
- 3. User Interface & Display Overview
- 4. BLE (Bluetooth Low Energy) Operation
- 5. Battery
- 6. Turning The Honeywell BW Solo On & Off
- 7. Navigation
- 8. Navigation: Information Menu
- 9. Navigation: Settings
- 10. Zeroing
- 11. Bump Testing
- 12. Calibrating
- 13. Replacing The Filter & Sensor
- 14. Maintenance
- 15. Firmware Update
- 16. Year Of Manufacture
- 17. Sensors & Settings
- 18. Troubleshooting
- 19. Honeywell BW Solo Specifications
- 20. Limited Warranty and Limitation of Liability
Honeywell BW Solo User Manual
40
Insert the sensor assembly into the instrument.
Tighten the screws to secure the assembly in place. Do not overtighten the screws.
Install a new filter over the sensor before replacing the cover.
13.5. Reinstalling The Cover
To reinstall the cover, align it over the compartment, press upper part into place first, and then
press the lower part until it clicks.
IMPORTANT!
Always calibrate the instrument after you replace the sensor. Failure to calibrate the instrument
can result in inaccurate readings. Some sensors require conditioning time before first use.