Install Instructions

C7031G; C7041B,C,F,K; T775-SENS-OAT/STRAP SERIES 2000 ELECTRONIC TEMPERATURE SENSORS
Automation and Control Solutions
Honeywell International Inc. Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MN 55422 Toronto, Ontario M1V 4Z9
customer.honeywell.com
® U.S. Registered Trademark
© 2008 Honeywell International Inc.
62-0220—03 J.I. Rev. 01-08
Strap-on Mounting (C7041K, T775-SENS-
STRAP)
The Sensor mounts on metal pipes from 1-5/8 inch to five
inches in diameter using the straps supplied. Clean the
pipe surface where the sensor makes contact before
mounting. If necessary, remove pipe insulation at the
installation point. Thermal compound is recommended.
Locate the sensor on the discharge pipe within 3 ft. (0.9
m) of the boiler. See Fig. 6.
NOTE: Insulation around the contact area increases
sensor accuracy.
Fig. 6. Strap-on Mounting of Sensor.
Fig. 7. Strap-on Dimensions in in. (mm).
M22136
SENSOR
PIPE
COPPER PLATE MUST
MAKE GOOD CONTACT
WITH METAL PIPE
WORM GEAR
2-5/16
(59)
4-3/16
(107)
4
(70)
1-11/16
(43)
7-1/8 (182)
9/16 (14)
1-1/2
(38)
1-1/2
(38)
2-5/16
(59)
M22134
1-1/4
(32)
5 (127)
MAXIMUM PIPE DIAMETER SHOWN.
MINIMUM PIPE DIAMETER: 1-5/8 (41)
1
1
4-3/16 (107)
COPPER PLATE
FOAM PAD