Wireless System Installation Instructions

Français : voir la page 17 • Español: vea la página 32
5 69-2090EFS—07
Link remote control to wireless network (optional)
Link outdoor sensor to wireless network (optional)
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press the connect button on the back of
the sensor.
3 Check thermostat to verify that the out-
door sensor is working. After about 15
seconds, the thermostat should display
outdoor temperature and humidity.
(If you are installing more than one zone
panel, repeat steps 1-3 for each.)
MCR28847A
Press and release
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press connect at the remote. There will
be a short delay as the remote seeks a
signal from the wireless network.
3 When the screen displays “Connected,”
press done.
4 Press no at the next screen to save and
exit. (Or press yes and repeat steps 1-4
to link another zone panel.)
If E1 appears, see error codes on page 12.
MCR32942
CONNECT
WIRELESS SETUP
MCR33902
NO
YES
CONNECT MORE?
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if pres-
ent) in the lower right corner of the screen until
the display changes (about 3 seconds)
Press to link another
zone panel
Press to save
and exit