Use and Care Manual

Honeycomb

Holder

Honeycomb

Holder

Screw

Honeycomb

Back Panel

Side Panel

DRAINING AND CLEANING THE WATER TANK

CLEANING THE HONEYCOMB COOLING MEDIA

•

Fig.1

Fig.2

Turn off the unit, and unplug the power cord from wall

outlet.

Rotate the unit facing the back panel, and locate the

Rear Grill Removal Screws.

Remove both the screws with a screw driver (refer fig. 1).

Pull the rear grill panel upwards, untill it is completely

removed.

Now, the honeycomb media can be seen. Clean both the

pads with clean cloth to remove all the dust & dirt

particles.

Repeat the same procedure in order to remove the

honeycomb pad from the side panel (refer to fig.2).

Once, the cleaning has been performed, assemble the

unit back in the same fashion as described above.

Water Drain Plug

Turn the power off and disconnect the unit from power supply.

Move the unit to a location where it can be drained and remove the

drainage tube/cap.

Once the tank is empty, refill with clean water and drain it again.

This should be repeated weekly to maintain the integrity of the unit

and to remove particles filtered from the air.

Once the tank is clean, refill the water tank. The unit is now ready to

be used again.

CLEANING & MAINTENANCE