Operation Manual

3
USE & OPERATION (CONTINUED)
EN
POWER
Press the POWER button to turn the unit on. The cooler will start automatically at medium speed.
After a few seconds the speed will switch to low. To turn the unit off, press the button again.
MODE
Press the MODE button to activate evaporative cooling and/or louver swing
modes.
Press the MODE button until the “S” indicator light is illuminated on the control
panel. The Vertical Louvers will begin to move left to right automatically.
Press the MODE button until the “C” indicator light is illuminated to activate
evaporative cooling. The water pump will operate and you will feel the cooler air
after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button until both “S” and “C” are illuminated will activate both Swing (Vertical
Louvers) and Cool modes simultaneously.
Note: When the “C” mode is not selected, the unit functions in a fan only mode, without evaporative
cooling.
FUNCTION BUTTONS
SPEED
Press the SPEED button repeatedly to change the speed between High - Medium - Low.
The indicator light will show the selected speed:
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is
unplugged from electrical socket). The TIMER function allows you to program the unit for up to 7.5
hours of use.
SWING(H)
Press the SWING (H) button until the indicator light turns on. This
activates the Horizontal Louvers and they will begin to move up and
down automatically.
Low (L)High (H) Medium (M)
LOUVER
MOVEMENT
LOUVER
MOVEMENT