Specification Sheet

51-52-03-36
Page 5
PC & Pocket PC Software
Features
• Create configurations with intuitive software program
running on either a Pocket PC, a Desktop or a laptop
computer.
• Create/edit configurations live, just connect software to
controller via comm port.
• Create/edit configurations offline and download to
controller later via comm. port.
• Port types optionally available on every UDC2500:
• Infrared
• RS-485
• Ethernet
• Same port types on UDC3200 and UDC3500 allow
interconnectivity
• This software is available in English, Spanish, Italian,
German and French.
Screen capture of the configuration software running on a
Pocket PC
Infrared Communications
The infrared connection provides a non-intrusive wireless
connection with the instrument and maintains NEMA4X and
IP66 integrity.
No need to get access to the back of the controller to
communicate with the instrument, no need to take your
screw driver to wire the communication cable, no wiring
mistake possible ! You can now duplicate an instrument’s
configuration, upload or download a new configuration in a
matter of seconds, just by pointing your Pocket PC in the
direction of the instrument.
Aim & Upload! It takes less than 2 seconds to upload a
configuration from an instrument ! You can then save the
configuration file onto your PC or pocket PC for review,
modification or archiving.
Furthermore, this software also gives you important
maintenance information on the controller : instantly, get
information on the current operating parameters, digital
inputs and alarm status, identify internal or analog input
problems.
Question : What if I have several controllers on the same
panel? How can I be sure I am communicating with the
correct one ?
Answer : The Infrared port is normally “off”. You activate the
infrared port on a particular controller by pressing any key.
You can now communicate with the controller. If no
communications are received for 2 minutes, the IR port will
be shut down again.
Ethernet Communications
Widely used by manufacturers, the Ethernet connection, which uses Modbus TCP/IP, allows the controller to connect to other
Ethernet networks and exchange data with computers or devices on that network for monitoring or managing your process
from almost any location.
The Ethernet cable can be connected to a hub (using a straight through cable) or directly to a PC (using a crossed cable or
straight through cable reconfigured at the UDC 2500 terminals)
The controller can be configured via the PC software. This software allows the user to configure all of the parameters
included in the instrument and to monitor various parameters in the controller.
The controller can be configured to send an Email when an alarm condition has been encountered. The Email address and
gateway are configured using the PC software.