DCP552 Mark II Digital Control Programmer User's Manual

8-9
● When the event is a code event
(1) In the set value display state, move to the event item to be set for the segment
on the programming map.
(2) Press the ENTER key to make display panel 1 flash (registration of first
setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the event
output code.
Setting range :0 to 2
n
– 1
(n indicates the number of output points set in event
configuration 1 auxiliary setting 1.)
(4) Press the ENTER key to stop the flashing on display panel 1.
(Pressing the FUNC and CLR keys causes display panel 1 to return to unset
state “-----” and the flashing stops.)
● Display (code event)
Unset values are indicated as “-----”.
NOTE
Code events use one subfunction. A subfunction cannot be used when a setting has
not been made “-----”.
Events that follow the event number of a code event (number of output points less
1) are skipped and not displayed.
Chapter 8. PROGRAM SETUP