User`s guide

6 - 2
Connecting the USB Cable
Connect the USB cable to the I/O connector to facilitate USB communication between the Dolphin
terminal and the host workstation.
ActiveSync Communication
To synchronize, ActiveSync 4.1 or higher must be installed and configured for the appropriate
communication type on the host workstation and the Dolphin terminal. Dolphin terminals ship with
ActiveSync already installed. Therefore, if ActiveSync is already installed on the host workstation, you just
need to connect the Dolphin terminal to the host workstation (via Dolphin peripheral) to initiate
communication.
Note: You can download the most current version of ActiveSync from www.microsoft.com.
When communicating via ActiveSync, your terminal is designed to be connected to the host workstation with
a Honeywell communication peripheral. We recommend use of Honeywell peripherals, power cables, and
power adapters. Use of any non-Honeywell peripherals, cables, or power adapters may cause damage not
covered by the warranty.
Communication Type
The 6100 supports the following type of communication via ActiveSync through its DC Power Jack (see
page 3-11) on the bottom panel:
USB The USB cable and hardware peripherals allow the Dolphin terminal to communicate with
a workstation or to networked through a USB hub. The Dolphin terminal supports full-speed
USB communication (USB 1.1); maximum data transfer rate is 12 Mbps. The Dolphin
terminal defaults to USB communication out of the box.
USB
Cable
I/O
Connector
Host
Workstation
USB
Connector
DC Power
Jack
!