User`s guide

12 - 6
Troubleshooting
If you encounter problems, refer to chart below for possible solutions. If problems persist, please contact
Technical Assistance (see page 15-1).
Problem Issue
The Status LED does not come on
when I insert a battery pack into a
slot.
Check the power connections; make sure the POWER switch is
ON and the battery pack is properly seated.
The Status LED lights red during
charging.
Try to charge the battery in one of the other charging slots. If the
red Status LED comes on again, then the problem is associated
with the battery pack. If the red status stays with the charging slot,
the problem is associated with the charging circuitry.
The Status LED lights red and stays
on without a battery in the charging
slot.
An error occurred during the self-diagnostic test for that particular
charging pocket. Call Honeywell Limited Warranty (see page 15-3)
to request an RMA.