User`s guide

3 - 13
Side Door
The rubber door on the left side panel provides access to the Headset and DC power jacks.
When closed, the side door seals the terminal from moisture and particle intrusion thus
preserving the terminal’s environmental rating.
Installing Memory Cards
This terminal supports microSD and microSDHC memory cards up to 4GB.
To install an SD card, you must open the access door on the side panel (Side Panel Features, page 3-
12). Access door removal requires a Torx 5 (T5).
1. Press the Blue + Backlight keys to put the terminal in Suspend Mode (see page 3-26).
2. Place the terminal on a flat, secure surface with the keyboard face-down.
3. Use a T5 screwdriver to remove the screw on the micro-SD door.
4. Remove the access door.
5. Slide the micro-SD card in with the contacts facing up (away from the keyboard) and the flat, straight
edge parallel to the top panel (with the imager).
Note: To remove an installed SD card while the access door is open, tap on the edge lightly to unlock
the card; the card will pop out just enough for you to grab its edge and pull it out.
Do NOT resume terminal operation while the access door is open! Operating the terminal
while the access door is open may cause damage not covered by the warranty.
!