User`s guide

Dolphin® 7900 User’s Guide Rev F
10/16/07
10 - 13
uPhone Configuration
uPhone Settings enable you to establish the normal operating parameters for uPhone applications.
Requirements
To open the uPhone configuration tools, the GSM radio must be enabled and an active SIM must be installed. The configuration
tools access the network directly. If you are not connected, settings cannot be configured and you will receive an error notification
when you attempt to open the configuration tools.
Accessing uPhone Configuration
You can access uPhone Settings two ways:
1. Tap Start > Settings > System tab > uPhone icon .
2. In the Dialler application, selecting Tools > Configuration.
An animated wait icon displays the following message while the system accesses the network.
If there is no response from the network within 60 seconds, this message times-out and the control panel closes.
If the network responds, the uPhone Settings screen displays; the General tab appears first by default.
Tab Windows
uPhone Configuration consists of five tabs: General, Network, Divert, Bar, and Messaging.
Tapping OK accepts any changes and exits the uPhone Configuration.
General Tab
Field Description
Phone Number
This is the phone number stored on the SIM. It is displayed here for information only.
Answerphone
This is the number to dial to retrieve voicemail messages. To enter a new number, tap on this
field and enter the digits.
Call waiting
Select On or Off to enable or disable call waiting functionality. Call waiting must be set to On
for conference calls.
PIN protection
Select On or Off to enable or disable PIN protection. If enabled, a PIN number is requested
when the phone is switched on.