Installation Instructions

Power up and bind the CS92 Transceiver
On the CS92 Transceiver
1
Remove the CS92 Transceiver cover
2
Remove the battery tab and replace the cover
3
On the CS92 Transceiver press and hold the
button for 5 seconds. The green light should
come on and the red light should flash
4
Press the button again
5
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
6
Choose the correct hot water valve type for the system
you’re installing and follow the on screen instructions
To control a stored hot water system you first need to bind
the CS92 Transceiver and then bind the Wireless Relay
Box (BDR91) that is controlling the hot water valve.
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
“Settings”
for 3
seconds
2. Press the green tick
3. Select GUIDED
CONFIGURATION
4. Press STORED
HOT WATER
CONFIGURATION
5. Press the green tick
evohome
Controller
HOLD
5 SEC
PRESS
ONCE
3
1 12
PULL TAB
Wireless Cylinder Thermostat (CS92)
16 Step 3: Power up and bind devices