Installation Instructions

Adding and replacing components in an
existing system
1
On the evohome Controller press and
hold “Settings” for 3 seconds
2
Press the green tick
3
To change a device in a zone press ZONE SETTINGS
and select the zone name To add or change an actuator
4
Press the application button then next and follow
the instructions to bind a new actuator
5
To change the sensor press the sensor button, select
the type of sensor or next and follow the instructions
to bind a sensor. If the old product is not required
in the system remember to remove the batteries as
it may still try to communicate with the system.
To change a boiler relay, system valve,
hot water component or remote gateway
1
Press SYSTEM DEVICE
2
Select the type of device and follow the instructions
to bind. If the old product is not required in the
system remember to remove the power as it may
still try to communicate with the system.
Adding and replacing components in an existing system
39evohome Installation Guide