Installation Instructions

Step 3: Power up and

bind devices

If you bought a Base Pack or a Connected Pack only — your devices are

already bound. Go to Step 4.

If you bought an unbound evohome Controller, plus other devices and

are using ‘Guided Conﬁguration’ follow the instructions on your evohome

Controller screen and use this section to put the devices into binding mode.

If you bought a Base Pack or a Mobile Connected Pack, plus other devices,

you need to power up all devices and then bind them to the evohome

Controller using the ‘Installation Menu’. It may be easier to power up and

bind some devices while they’re close to the evohome Controller – you can

install them in their assigned zones later.

Follow the instructions for the device(s) you’re going to bind. When you

bind a device to the evohome Controller the devices permanently store the

connection and there should never be a need to rebind them even after a

power cut.

In this section

Radiator Controllers (HR92) 14

Wireless Cylinder Thermostat (CS92) 16

Remote Access Gateway (RFG100) 18

Wireless Relay Box (BDR91) 19

Radiator Controller (HR80) 22

Underﬂoor Heating Controller (HCE80 or HCC80) 24

Mixing Valve Controller (HM80) 27

13evohome Installation Guide