Installation Instructions

Power up and bind Radiator Controllers
(HR92) – Your evo Zone Kit
Bind the Radiator Controllers (HR92)
1
Remove the circular top cover
2
Open the battery clip and insert the AA batteries supplied
3
Close the clip and replace the cover
4
Press the button once − it should say UNBOUND
5
Press and hold the button for a further
5 seconds until it says BIND
6
Press the button once – it should say BINDING
7
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
8
The name of the allocated zone should appear on
the HR92 display when you press the button
9
Either press the green tick to add another
radiator to the zone. Or press the red cross if
you don’t need to add another radiator to the zone
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
‘Settings’
for 3
seconds
2. Press the green tick
3. Press ADD ZONE
4. Press the zone you
want to add the
Radiator Controller to
5. Rename the zone if
required and/or press
the green tick
6. Press RADIATOR
VALVE
7. If you want to control
the zone temperature
with the evohome
Controller (which
needs to be located in
that zone) press YES,
otherwise press NO.
You must repeat these
steps for each radiator
controller.
evohome
Controller
1 2 4 5 6
PRESS
ONCE
PRESS
5 SEC
PRESS
ONCE
Radiator Controllers (HR92)
14 Step 3: Power up and bind devices