Installation Instructions

10 Step 2: Set up your Central Controller
First, power up the evohome Controller
1
Remove the cover, remove the battery
tab and replace the cover.
2
Place it on the table stand or wall bracket
3
Once the batteries are fully charged, the evohome
Controller can be easily removed from the table stand or
wall bracket for ease of programming. After 30 minutes
the evohome Controller will emit a beep to indicate that
it should be replaced on the stand or wall bracket
Your evohome
Controller comes
with *rechargeable
batteries which are
pre-charged allowing
you to set-up the system
while off the table
stand or wall bracket.
Place the evohome
Controller on the table
stand or wall bracket
for normal use.
*Only use the
AA rechargeable
batteries provided.
!
1
Powering up your evohome Controller
PULL TAB