Installation Instructions

14 Step 3: Power up and bind devices
Power up and bind Radiator Controllers
(HR92) – Your evohome Zone Kit
Bind the Radiator Controllers (HR92)
1
Remove the circular top cover
2
Open the battery clip and insert the AA batteries supplied
3
Close the clip and replace the cover
4
Press the button once − it should say UNBOUND
5
Press and hold the button for a further
5 seconds until it says BIND
6
Press the button once – it should say BINDING
7
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
8
The name of the allocated zone should appear on
the HR92 display when you press the button
9
Either press the green tick to add another
radiator to the zone. Or press the red cross if
you don’t need to add another radiator to the zone
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
‘Settings’
for 3
seconds
2. Press the green tick
3. Press ADD ZONE
4. Type a name for the
new zone and press
the green tick
5. Press RADIATOR
VALVE
6. If you want to control
the zone temperature
with the evohome
Controller (which
needs to be located
in that zone) press
YES, otherwise press
NO.
You must repeat these
steps for each radiator
controller.
evohome
Controller
Radiator Controllers (HR92)
1
2
4
5
6
PRESS
ONCE
PRESS
AND HOLD
5 SEC
PRESS
ONCE