Installation Instructions

22 Step 3: Power up and bind devices
Power up and bind a Radiator Controller
(HR80)
If you want to control the zone temperature with your evohome
Controller (the evohome Controller needs to be located in that
zone) press YES, otherwise press NO and bind the sensor.
On the HR80, you need to bind the
sensor and actuator separately
1
Power up the Radiator Controller (see HR80 instructions)
To bind the sensor
2
Turn release clips on each side of the Radiator
Controller to remove the bottom plate
3
On the underside of the Radiator Controller
press the recessed bind button
4
The Radiator Controller screen should briefly show
a flashing RF icon then SYNC when successful.
The evohome Controller will also show if binding
was successful (if not go back and re-bind)
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display first:
1. Press and hold
“Settings”
for 3
seconds
2. Press the green tick
3. Press ADD ZONE
4. Type a name for the
new zone and press
the green tick
5. Press RADIATOR
VALVE
evohome
Controller
Radiator Controller (HR80)
2
3
SIDE VIEW BOTTOM VIEW