Installation Instructions

26 Step 3: Power up and bind devices
Then on the underfloor controller
1
Press and hold the bind button until the bind
light turns solid YELLOW and the zone number
light flashes (either GREEN or RED).
Follow the instructions below depending on which colour the
zone number light is flashing:
If the zone light is flashing GREEN (single stage bind):
2
On the evohome Controller, press the green bind button
3
When the zone light turns solid YELLOW the
binding is successful for the zone
4
Press forward on the evohome Controller
to complete the binding for this zone
If you are binding more zones repeat the process from
the sensor binding step on the previous page, then press
the bind button twice on the Underfloor Heating
Controller - The GREEN light will flash on the next zone.
If the zone light is flashing RED (two stage bind):
2
On the evohome Controller, press the green bind button
3
When the message is received the
zone light will turn solid RED
4
Press the back arrow on the evohome Controller
5
Press the bind button on the Underfloor Heating
Controller – the zone light should flash GREEN
6
On the evohome Controller, press the green bind button
7
When the zone light turns solid GREEN the
binding is successful for the zone
8
Press forward on the evohome Controller
to complete the binding for this zone
If you are binding more zones repeat the process from
the sensor binding step on the previous page, then press
the bind button once on the Underfloor Heating
Controller - The RED light will flash on the next zone.
There are two versions
of HCE80/HCC80,
newer versions have a
simplified single stage
bind process while older
versions have a two
stage bind process.
Note the colour of the
flashing zone light
(GREEN or RED) and
follow the instructions for
that version. Put a tick
next to the version for
future reference.
!
Underfloor Heating Controller (HCE80 or HCC80) continued