Air Cleaner Manual

F116 SERIES 2 SELF-CONTAINED DUCTABLE COMMERCIAL AIR CLEANER
11 68-0200-4
Fig. 14. Box plenum with diffusion screen and three inlets
connected to the air cleaner inlet.
On the outlet, use a square-to-round or square-to-square
connection when attaching the air cleaner outlet to the blower
discharge flange, see Fig. 15. The outlet connection can be
used with a Y-branch, distribution box or manifold as required.
Fig. 15. Square-to-round connection attached to the air
cleaner outlet.
Electrical Hookup
All wiring must comply with applicable codes and ordinances.
The power source must agree with the model type: 120V,
60 Hz or 230V, 50 Hz. Refer to figure 16 for electrical
connection setup.
1. Remove screws on motor compartment cover and
remove.
2. Refer to figure 16 for typical electrical diagram
WARNING
Risk of Fire or Electric Shock.
Can cause personal injury or equipment damage.
Use only Honeywell 190097C Remote Speed Switch
(3-speed models only) to regulate air cleaner speed.
Using a different speed switch may void the warranty.
IMPORTANT
• Be sure the air cleaner is grounded for correct
operation and safety.
• Canadian installation: NEVER install in ceilings with
thermal insulation value greater than R-40.
Fig. 16. Typical F116 Series 2 only 120V, 60 Hz or
230V, 50 Hz wiring diagram.
Remote 3 Speed Wall Switch
(F116 Series 2)
The 190097C Remote Wall Switch Assembly allows control of
the F111 model air cleaners from a a location separate from
the air cleaner. The assembly includes a remote switch with
an outlet box cover, outlet box, extension ring, and a wire
harness. Wiring to connect the remote switch and air cleaner
must be furnished separately.
CAUTION
• This installation to be performed only by a qualified
installer.
• All wiring to comply with local electrical codes.
• Disconnect power to air cleaner at fuse or breaker
before beginning work. Failure to do so can result in
shock hazard endangering equipment and personal
safety of installer.
• Only one air cleaner can be connected to a remote
switch
1. Disconnect power to air cleaner.
2. Mount 4” x 4” outlet box at desired remote location.
3. Attach 3/4” extension ring to outlet box.
4. Run five conductor, color-coded, 14-gauge wires from
the remote switch location to the air cleaner.
5. Use three wire nuts to connect three color-coded, lead
wires on the remote switch to three color-coded wires
from the air cleaner. (Red, Blue, Violet)
6. Use one wire nut to connect white color-coded, lead
wire from the air cleaner to single color-coded wire from
the power supply. (White)
DIFFUSION
SCREEN
M10803
AIR
CLEANER
M7792A
AIR CLEANER
SQUARE-TO-ROUND
CONNECTION
Y-BRANCH
A100002
CAPACITOR
WHITE
GREEN
BLACK
FACTORY WIRING
BROWN
EXTERNAL
WIRING BY
INSTALLER
MOTOR
BLUE
VIOLET
RED
BLACK
REMOTE 3-SPEED
SWITCH