Installation Manual

Program Mode
38
411UDAC Document #51073 Rev. D 12/09/2008 P/N 51073:D
Upon accessing the first event code address (address 145) shown in Table 3-2 , the following may be displayed on the
Programmer 7-Segment Display, if the corresponding Format was selected in address 20.
The first three locations on the left of the Programmer display represent the memory address 145 of the Format previ-
ously selected in address 20. The last location 1 (farthest right) represents the contents of memory address 145
(which is the first digit of the event code).
The following Tables list the data which is automatically programmed for each Format that can be selected in address
20. The addresses shown in each Table contain the Setting data which is automatically programmed by the
411UDAC. To change the value, key in the new digit and then press the [ENTER/STORE] key to save the new
value. Use the Up and Down Arrow keys to increment to the next address or decrement to the previous address.
1451
(address)
(data)