User`s guide

Cable Installation and Removal

Installation

1. Insert the cable’s modular connector into the socket on the imager.

2. Pull gently on the cable strain relief to ensure the cable is installed.

Note: If the cable is not fully latched, the imager may power intermittently.

Figure 3. Installing the Cable

Removal

Turn the host power off and disconnect the power supply from the cable before

attempting to disconnect the cable from the imager.

1. Locate the small pinhole on the imager near the cable connection point.

2. Bend a paperclip into the shape shown below.

3. Insert the paperclip into the pinhole and apply pressure to release the

connector lock.

4. Pull gently on the strain-relief of the cable to remove the cable from the

imager.

Figure 4. Disconnecting the Cable

MS7580-124-EAS Model Note

See page 35 for additional cable installation/removal instructions specific to the

MS7580-124-EAS Genesis with integrated RF EAS antenna.