Operation Manual

Rev 1.01 9 900.0355
01/06
Tact Switch Operation
This camera uses a Set Up Menu that is displayed on a
connected monitor. To set items in the Set Up Menu, use the
following buttons located in the side panel.
Figure 9 Side Panel Buttons
Up Key This button is used to move the cursor upwards.
Down Key This button is used to move the cursor
downwards.
Right Key This button is used to move the cursor to the right.
Use this button to select or adjust the parameters of the
selected item. The parameter changes each time this button is
pressed.
Left Key This button is used to move the cursor to the left.
Use this button to select or adjust the parameters of the
selected item. The parameter changes each time this button is
pressed.
Set Key This button is used to set the determined parameter.
If the item has its own setting menu (indicated by ), press this
button to display the next page of the setting menu.
Opening the Set Up Menu
1. Press and hold SET for 3 seconds. The Set Up Menu will
appear on the monitor as shown in Figure 10.
Figure 10 Set Up Menu
Down
Right
Up
Left
Set Key
Set Up Menu
Sync Int
Shutter 1/50
Lens Bright
BLC Off
Configure Aperture
Cam Title Off
White Bal WB-Auto
D/N Fuzzy
RS-485 Setting
Exit Cancel Reset