Operation Manual

18
2. Press the menu control UP, DOWN, LEFT, or RIGHT to select a character,
then press SETUP (MENU) to accept it. The character is saved and the title
cursor at the bottom of the screen moves to the next position. You can use
the
" $ symbols to go back or forward in the title name to make changes,
and you can also select CLR to delete the entire title and start again.
3. Repeat step 2 until your camera title is complete.
4. Select POS to position where you would like the camera title to be located
on screen. Select the position using the menu control, then press (SETUP)
MENU to confirm the position.
5. Select END when you are finished.
Sync Control/Line-lock Setup
This screen allows you to synchronize the vertical interval sync pulse of your
camera with other equipment to reduce the effect of picture roll on the monitor.
Linelock mode is only available when using 24 VAC power.
Figure 7 Sync Control Setup
Menu Item Description
INTERNAL When line lock is not required.
LINELOCK Adjust the vertical phase (VPH):
VPH: 000–359 (factory default is 0)
RETURN Press MENU to return to the SETUP MENU.
<SYNC. CONTROL>
SYNC INT (L/L)