Operating instructions

6
ENGLISH
FIRST TIME OF USE
1.
Read through all the instructions before using
the humidifier.
2. Unpack the humidifier, the Power cable (20),
the Water Tank (3), the Directional Mist Nozzle
(1), the Base (11) and the Demineralization
Cartridge (13); remove all packaging material
and discard. Packaging material can be recycled.
3. Place the humidifier on a level, firm, non-metallic
and waterproof surface. Make sure it is in a
stable position, so that it cannot fall over or fall
down. Water can damage furniture and floors.
A safety distance of at least 1.20 m from any
objects must be kept.
4. Soak the Demineralization Cartridge (13) in
cool tap water for two hours prior to use in
order to achieve best filter results.
5. Check your water hardness.
DEMINERALIZATION
CARTRIDGE AC-819E
1.
The durability and performance of the AC-819E
Cartridge (13) depends on the mineral content
of the water. It can be used for a water hardness of
up to 15° dH. Its lifetime for 0-10° dH is approx. five
months and for 10-15° dH approx. three months.
Ask your local water supplier for information
about the water hardness in your area.
2. When using the humidifier under normal
conditions the Cartridge (13) should be repla-
ced every three to five months at the latest.
3. If the humidifier has not been used for a longer
period of time (e.g. over the summer season),
the Cartridge (13) must be replaced by a new
one. Soak the Demineralization Cartridge (13)
in cool tap water for two hours prior to use in
order to achieve the best filter results.
4. Replacement AC-819E Cartridges (13) are
available where you purchased your humidifier.
5. Do not operate the humidifier without the
Demineralization Cartridge (13) and do not
use an exhausted Cartridge. In areas, where
water is very hard, there might be an output
of minerals, noticeable as “white dust”
(see extra filters).
EXTRA FILTERS
In areas where the water is very hard there might
be an output of minerals, noticeable as “white dust”.
In order to determine the hardness of the water you
may ask your local waterworks.
KF-520E K-Filter
1.
If the water is extremely hard the cold tap water
should be filtered with the KF-520E K-Filter
before filling it into the Water Tank (3).
2. The KF-520E K-Filter reduces the calcium
carbonate content of the water.
3. The KF-520E K-Filter can be regenerated and
therefore has a long lifetime.
4. For using the KF-520E K-Filter, please read
and follow carefully the special instructions
included in each filter package.
SF-530E A-Filter
1.
The SF-530E A-Filter should be used when salt
is added to the water by use of a water softening
plant. If the water has an extremely high salt
content the cold tap water should first be filtered
with the SF-530E filter.
2. Then filter the water with the KF-520E K-Filter.
The water, filtered twice, can now be filled into
the Water Tank (3).
3. The SF-530E A-Filter can be regenerated and
therefore has a long lifetime.
4. For using the SF-530E A-Filter, please read
and follow carefully the special instructions
included in each filter package.
FILLING THE WATER TANK
1.
Check that the Power Switch (5) is in the Off
position and that the plug is not in the socket.
2. Remove the Directional Mist Nozzle (1) from
the Water Tank (3).
3. Remove the Water Tank (3) from the Base (11)
and turn it upside down. Open the Tank Cap
(9) by turning it counter-clockwise.
4. Fill the Water Tank (3) only with clean, cool
tap water (approx. 7,7 litres). Do not use warm
or hot water. This can damage the Cartridge
(13) and the Ultrasonic Nebulizer (17) and
void the warranty.
5. Do not add any substances into the Water
Tank (3), the Reservoir (15) or onto the
Cartridge (13) (e.g. inhalant, aromatic sub-
stances etc.). This can cause health hazards
to people.
6. Close the Water Tank (3) with the Tank Cap (9)
by turning it clockwise.
7. Make sure the Demineralization Cartridge (13)
is properly located and secured in the reservoir
(15) with the water tray (12) located on top.