Operation Manual

www.honeywell.com/security
70 | Performance Series Full Poe Embedded NVR Remote User Guide
Network Alarm are the alarm signals from the TCP/IP. You cannot select the sensor type or
anti-dither functions.
Click Net Alarm in the ALARM configuration interface.
PTZ Activation When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click Setup to open the PTZ Activation configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click Save.
Tour Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. See Configuring Display Settings
on page 80 for tour interval setup. On the Display Settings
tab, when there are two tours enabled by default, you can
configure the system so an alarm triggers the system to
enable the alarm tours you configured here. If there is no
alarm, then the system uses the tour setup that was
configured in the Display interface.
Snapshot Click to enable the Snapshot function. Channel snapshots
are taken according to the schedule you configure. Alarm
snapshots are taken when an alarm occurs.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
SettingNetworkEmail to configure the email
settings. See Configuring Email on page 50.
Alarm Upload Select the check box to enable the system to upload an alarm
signal to the network (including to an alarm center and/or web
client).
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Table 3-15 WEB - Alarm Configurations
Configuration Description