Operation Manual

Configuring System Settings | 131
800-21090V2 - A - 03/2016
To configure a tour
1. Go to Main Menu > SETTING > SYSTEM > DISPLAY > Tour.
Figure 10-6 Tour Configuration Tab
2. If you want, you can add or delete cameras from the Channel Group list. You can only add
cameras that do not already appear in the list.
Note On some NVR models you can change the Motion Tour Type and Alarm Tour
Type from View 1 (single-channel view) to View 4 (four-channel view).
3. Select the Enable Tour check box to enable the tour function or clear the check box to disable
the tour function.
4. In the
Interval box, enter the amount of time in seconds that you want each view to appear on
the screen. The default setting is
5 seconds.
5. Do one of the following:
• To cycle through all of the cameras in all of the available views, keep the default settings.
• To create a custom tour, for each view in the
Window Split list ( View 1 , View 4 , ...), clear
the check box on the top row of the Channel Group list to deselect all of the cameras for
that view, then select the cameras for each view that you want to appear in the tour.
For example, to create a tour showing only cameras 2, 3, and 5 in single-channel view,
set
Window Split to View 1 and then select cameras 2 , 3 , and 5 . There should be no
other cameras selected in View 1 or in any of the other views.
6. Click Apply to save your settings.
7. If you want to save your settings and exit the SETTING menu, click Save.