Operation Manual

NVR Configurations | 107
800-18160 - A - 06/2014
Configuring PTZ Settings
Note All the operations here are based on the PELCOD protocol. For other protocols,
there might be slight differences.
Cable Connection Before You Begin
Ensure that the following are connected:
• Connect the camera’s RS485 port to the NVR’s 485 port.
• Connect the camera’s video output cable to the NVR’s video input port.
• Connect the power adapter to the camera.
Before You Begin PTZ Configuration
Ensure that:
• The PTZ and decoder connection is correct, and that the decoder address configuration is
correct.
• The decoder’s A (B) line connects with the NVR’s A (B) line.
Note The camera video should be in the current screen for configuring Pan/Tilt/Zoom
settings.
Configuring PTZ Settings
1. Click the PAN/TILT/ZOOM icon in the Setting interface to open the
Pan/Tilt/Zoom configuration interface.