Operation Manual
NVR Configurations | 113
800-18160 - A - 06/2014
Note You must click Save to save the new settings.
Note The system menu color, language, time display mode, video format, IP address,
and user account will not keep any custom settings if you default the NVR.
Connecting to and Configuring the Remote Devices/Cameras
Note Do NOT connect the switch to the PoE port. If you do, then the connection might
fail.
Depending on your model, your NVR can support up to 16 channels, with a transmission rate of
8Mbps. It supports 100/120 @ 1080p. The delay time for each channel is below 500 ms.
Your NVR supports IP cameras from many popular manufacturers such as Honeywell, Sony,
Hitachi, Dynacolor, Axis, Samsung, Arecont, Dahua, and Onvif. Just enter the camera’s URL
address, user name, and password to log in to the camera.
Connect the cameras to the PoE ports on the NVR’s rear panel.
Figure 3-57 NVR Real Panel - PoE Ports
The NVR automatically searches for and connects to the network cameras.
Note The four-channel NVR back panel is shown here as an example. The back panel
of the eight-channel and 16-channel NVRs will be slightly different.
Configuring the Built-in Switch Setup
1. Open the Switch Settings configuration interface.
On the Main Menu interface, click Setting
NetworkNetwork Setting, then
double-click Switch Setting.