Operation Manual

Web Operation | 161
800-18160 - A - 06/2014
Figure 5-22 Manual Add Configuration Window
Remotely Configuring Video and Audio
Configuring Encoding for Video and Audio
Click Video&Audio in the REMOTE configuration interface to open the Video&Audio
configuration interface.
Delete Select a camera in the Added device list, and then click Delete.
The system disconnects from the camera and removes it from the
Added device list.
Manual Add 1. Click Manual Add, and the Manual Add configuration
interface appears. See Figure 5-22.
2. Select a channel from the drop-down list. Only disconnected
channels are shown.
Note The NVR supports cameras from Honeywell, Panasonic,
Sony, Dynacolor, Samsung, AXIS, Arecont, Dahua, and
cameras with ONVIF-standard protocol.
Note If you do not enter an IP address, the system uses the
default IP address 192.168.0.0, and the system does
not connect to this IP address.
Note You can not add two devices at the same time. If you click
OK, the system connects only to the camera for the
currently selected channel.
Table 5-8 Remote - Add Device Configurations
Configuration Description