Operation Manual
Web Operation | 183
800-18160 - A - 06/2014
Configuring for Video Loss Detection
You can configure the system to generate a video loss alarm when the minimum amount of
video loss (as defined by you) is detected in the video.
Note Video loss does not support anti-dither, sensitivity, or region setup.
Click Video Loss in the Event configuration interface to open the Video Loss configuration
interface.
Figure 5-42 Video Loss Configuration Interface
The configuration for Video Loss Detection is very similar to the configuration for Motion
Detection. Please see Configuring for Motion Detection on page 179 for more information.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
Setting NetworkEmail to configure the email
settings. See Configuring Email Settings on page 173.
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Table 5-19 Motion Detection Configurations
Configuration Description